Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY OPERATOR'S CAB When installing the operator's cab, obey the fol- lowing points. 1) Lower the operator's cab assembly onto the floor frame slowly. a Since the reaction force of the seal sponge is large, lower the operator's cab assembly slowly. a Check that the air conditioner duct seal on the cab side is tightly in contact with the air conditioner duct on the dashboard side and there is not clearance. a Since the clearance between the air con- ditioner duct on the cab side and the monitor is narrow, lower the operator's cab assembly carefully. 2) Tighten the mounting bolts temporarily.

3) Check that the seal between air conditioner bracket (17) and cab (18) is fitted securely. 4) Check that there is not clearance at joint a of the seal and front frame. Parts to be installed before operator's cab is mounted 1) Install open lock stopper mounting grip (29). 5) Check that clearance e between cab-side air conditioner duct (26) and monitor (27) is even on both sides. At the same time, check that cab-side air conditioner duct seal f is fit- ted to faces C on both sides of dashboard- side air conditioner duct without deviating to the right or left.

a If clearance e between the cab-side air conditioner duct and monitor is not even, loosen the mounting screws of the cab- side air conditioner duct and move the duct so that the clearance will be even. Similarly correct the deviation of the cab and air conditioner to the right or left, if necessary. 6) Tighten the mounting bolts of the dashboard mounting bracket. 7) Measure the internal pressure. For details, see TESTING AND ADJUSTING OPERA- TOR'S CAB. 2) Install cab mounting L-plate (10) to the cab. 30-193-1 D85EX-15 (5)