Komatsu — REMOVAL

DISASSEMBLY AND ASSEMBLY OPERATOR'S CAB GLASS (STUCK GLASS) SPECIAL TOOLS (The following figure shows the operator's cab of a wheel loader.) REMOVAL * Remove the window glass to be replaced according to the following procedure. 1. Using seal cutter [1], cut the adhesive between broken window glass (6) and operator's cab (metal sheet) (7). a If the window glass is broken finely, it may be removed with knife [4] and a screwdriver. a Widening the cut with a screwdriver, cut the adhesive and both-sided adhesive tape with knife [4].

(The following figure shows the operator's cab of a wheel loader.) a If a seal cutter is not available, make holes on the adhesive and both-sided adhesive tape with a drill and pass a fine wire (piano wire, etc.) [2] through the holes. Grip the both ends of the wire with priors [3], etc. (or hold them by winding them onto something) and move the wire to the right and left to cut the adhesive and both-sided adhesive tape. Since the wire may be broken by the fric- tional heat, apply lubricant to it. 2. Remove the window glass. D85EX-15 30-195 (2) Symbol Part No. Part name Necessity Q'ty New/Remodel Sketch X 1 793-498-1210 Lifter (Suction cup) t 2