Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY OPERATOR'S CAB GLASS (STUCK GLASS) INSTALLATION 3. Stick both-sided adhesive tape (3) along the inside edges of the front window glass sticking section and both door window glass sticking sec- tions. a Do not remove the release tape of the both- sided adhesive tape on the glass sticking side before sticking the glass. a When sticking the both-sided adhesive tape, do not touch the cleaned surface as long as possible. a Take care that the both-sided adhesive tape will not float at each corner of the window frame. a Do not lap the finishing end of both-sided adhesive tape (3) over the starting end but make clearance (a) of about 5 mm between them. 1.

Using a knife and scraper [5], remove the remaining adhesive and both-sided adhesive tape from the metal sheets (glass sticking sur- faces) of the operator's cab. a Remove the adhesive and both-sided adhe- sive tape to a degree that they will not affect adhesion of the new adhesive. Take care not to scratch the painted surfaces. (If the painted surfaces are scratched, adhe- sion will be lowered.) (The following figure shows the operator's cab of a wheel loader.) 2. Remove oil, dust, dirt, etc. from the sticking sur- faces of cab (7) and window glass (8) with white gasoline. a If the sticking surfaces are not cleaned well, the glass may not be stuck perfectly.

a Clean the all black part on the back side of the window glass. a After cleaning the sticking surfaces, leave them for at least 5 minutes to dry. 30-196 D85EX-15 (2)