DISASSEMBLY AND ASSEMBLY OPERATOR'S CAB GLASS (STUCK GLASS) 4. Install trim seals (4) to both door window glasses (2). 5. Position the new window glass. 1) Using tool X1 , set the window glass to the sticking position. Check the clearance between the window glass and the operator's cab on the right, left, upper, and lower sides, and then adjust it evenly. a Position front window glass (1) from inside of operator's cab (7). Adjust it so that the difference between black coated part and the metal sheet of operator's cab (7) will be even on the right, left, upper, and lower sides.
a When positioning each door window glass (2), align handle holes (d) of door (9) (on the glass side and door metal sheet side) first. Then, adjust the door window glass so that the positional rela- tionship between it and door metal sheet will be even all around the window. a Install each trim seal (4) so that its finishing end and starting end will be jointed at posi- tion (c) and dimension (b) between the cor- ner and position (c) will be 90 mm. 2) After positioning the glasses, stick tapes [6] between front window glass (1) and opera- tor's cab (7) and the right, left, and lower parts of each door window glass (2) and each door (9), and then draw positioning line (e).
3) Cut the tapes between window glasses (1) and (2) and operator's cab (7) with a knife, and then remove the window glasses. a Do not remove the tapes left on the win- dow glasses and operator's cab before installing the window glasses. D85EX-15 30-197 (2)