Komatsu — INSTALLATION

DISASSEMBLY AND ASSEMBLY OPERATOR'S CAB GLASS (STUCK GLASS) 1) Break aluminum seal (11) of the outlet of adhesive cartridge (10) and install the noz- zle. 6. Apply adhesive. 2 Adhesive: Sikaflex 256HV manufactured by Sika Japan a Do not use primer. a The using limit of the adhesive is 6 months after the date of manufacture. Do not use the adhesive after this limit. a Keep the adhesive in a dark place where the temperature is below 25°C. a Never heat the adhesive higher than 30°C. a When reusing the adhesive, remove the all hardened part from the nozzle tip. 2) Cut the tip of the adhesive nozzle (12) so that dimensions (f) and (g) will be as follows. Dimension (f) : 10 mm Dimension (g):

15 mm 3) Set adhesive cartridge (10) to caulking gun [7]. a An electric caulking gun is more efficient. 30-198 D85EX-15 (2)