Caterpillar — GENERAL HAZARD INFORMATION

12 Safety Section General Hazard Information Fuel Injectors 101159865 General Hazard Information SMCS Code: 1000; 7405 Attach a “Do Not Operate” warning tag or a similar warning tag to the start switch or to the controls before the engine is serviced or before the engine is repaired. These warning tags (Tag, SEHS7332) are available from your Caterpillar dealer. Attach the warning tags to the engine and to each operator contro! station. When it is appropriate, disconnect the starting controls. ll g00580495 Ilustration 12 The unit injector warning label is located on the electronic control module (ECM) (1) and the valve covers (2).

yee ELECTRICAL UNIT SHOCK HAZARD Hlustration 13 INJECTOR SYSTEM 90-120 VOLTS 9¥-4294 g00104545 Do not allow unauthorized personnel on the engine or around the engine when the engine is serviced. 2 g00103125 Engine exhaust contains products of combustion which may be harmful to your health. Always start the engine and operate the engine in a well ventilated area. If the engine is in an enclosed area, vent the engine exhaust to the outside. Electrical shock hazard. The electronic unit injector system uses 90-120 volts. The ECM sends a high voltage signal to the fuel injectors. To help prevent personal injury, disconnect the fuel injector connector.

Do not come in contact with the harness connector for the fuel injector while the engine is operating. Cautiously remove the following parts: e Filler caps e Grease fittings e Pressure taps e Breathers e Drain plugs To help prevent spraying or splashing of pressurized fluids, hold a rag over the part that is being removed. Use caution when cover plates are removed. Gradually loosen but do not remove the last two bolts or nuts that are located at opposite ends of the cover plate or the device. Before removing the Jast two bolts or nuts, pry the cover loose in order to relieve any spring pressure or other pressure.