13 Safety Section General Hazard e Wear a hard hat, protective glasses, and other protective equipment, as required. Information If fluid is injected into the skin, seek treatment immediately. Seek treatment from a doctor that is familiar with this type of injury. e@ When work is performed around an engine that is operating, wear protective devices for ears in order to help prevent damage to hearing. Fluid Spillage e Do not wear loose clothing or jewelry that can snag on controls or on other parts of the engine. fluids are contained during the inspection, the e Ensure that all protective guards and all covers are secured e Never in place on the engine.
put maintenance fluids into glass containers. Glass containers can break, e Use all cleaning solutions with care. e Report all necessary repairs. Ensure that the engine e Disconnect the batteries when maintenance is performed or when the electrical system is serviced. Disconnect the battery ground leads. Tape the leads in order to help prevent sparks. e Do not attempt any repairs that are not understood. Use the proper tools. Replace any equipment that is damaged must be used in order to ensure that the maintenance, the testing, the adjusting, and the repair of the engine.
Make provision to collect the fluid with a suitable container before any compartment is opened or before any component is disassembled. Refer to the Special Publication, NENG2500. This publication explains the items that are needed for collecting and for containing fluids that are used in Caterpillar engines. Dispose of fluids according to local regulations. Asbestos Unless other instructions are provided, perform the maintenance under the following conditions: e The engine is stopped. cannot be started. Care Information Caterpillar equipment and replacement parts that are shipped from Caterpillar are asbestos free.
Caterpillar recommends the use of only genuine Caterpillar replacement parts. Use the following guidelines when any replacement parts that contain asbestos or debris that contains asbestos are handled. The asbestos in these components is usually sealed or bonded in a resin. Handling these materials normally is not hazardous unless airborne dust that contains asbestos is generated. or repair the equipment. Pressurized Air and Water Pressurized air and/or water can cause debris and/or hot water to be blown out. This could result in personal injury. When pressurized air is used for cleaning, wear a protective face shield, protective clothing, and protective shoes.
The maximum air pressure for cleaning purposes must be below 205 kPa (30 psi). The maximum water pressure for cleaning purposes must be below 275 kPa (40 psi). Always wear eye protection for cleaning the cooling system. Fluid Penetration Do not inhale dust that might be generated when components that contain asbestos fibers are handled. Inhaling this dust can be hazardous to your health. If dust which may contain asbestos is present, follow these guidelines: e Never use compressed air for cleaning. e Avoid abrasion of materials that contain asbestos. e Use a wet method to clean up asbestos debris.
A vacuum cleaner that is equipped with a high efficiency particulate air filter can also be used. e Use exhaust ventilation when asbestos are machined. parts that contain e@ Wear an approved respirator if there is no other way to control the dust. e Comply with applicable rules and regulations for Always use a board or cardboard when the engine the work place. In the USA, use the Occupational components are checked for leaks. Leaking fluid Safety and Health Administration requirements. that is under pressure can cause serious injury or possible death. This includes leaks that are the size These of a pin hole. CFR OSHA requirements can be found in “29 1910.1001”.