Caterpillar — FIRE PREVENTION AND EXPLOSION PREVENTION

14 Safety Section Burn Prevention e@ Obey environmental regulations for disposal of asbestos. Any contact with hot coolant or with steam can cause severe burns. Allow cooling system e Stay away from areas that might have asbestos components to cool before the cooling system is drained. particles in the air. Check the coolant level only after the engine has Lines, Tubes, and Hoses been Do not bend or strike high pressure lines. Do not Do not step on the engine in order to remove the filler cap. Use a ladder, if necessary. Ensure that the filler cap is cool before removing the filler cap. Remove the filler cap slowly in order to relieve install lines, tubes, or hoses that are damaged.

Repair any fuel lines, oil lines, tubes, or hoses that are loose or damaged. Leaks can cause fires. for leaks. Always use a board or cardboard for checking engine components for leaks. Tighten all connections to the recommended torque. Check for the following conditions: Oils Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin. e End fittings that are damaged or leaking e Outer covering that is chafed or cut e Wire that is exposed pressure. Cooling system conditioner contains alkali. Alkali can Cause personal injury. Do not allow alkali to contact the skin, the eyes, or the mouth. Inspect all lines, tubes and hoses carefully.

Do not use bare hands to check stopped. Keep all of the exhaust manifold and turbocharger shields in place in order to protect components from oil spray if there is a failure of a line, a tube, or a seal. in reinforced hose e Outer covering that is ballooning locally e Flexible part of the hose that is kinked or crushed e Armoring that is embedded in the outer covering Ensure that all of the clamps, the guards, and the heat shields are installed correctly. This will help to prevent these effects: vibration, rubbing against other parts, and excessive heat during operation. Batteries Electrolyte is an acid. Electrolyte can cause personal injury.

Do not allow efectrolyte to contact the skin or the eyes. Always wear protective glasses for servicing batteries. Wash hands after touching the batteries and connectors. Use of gloves is recommended. Batteries give off combustible gases which can 100910250 Burn SMCS Prevention Code: 1000; explode. Ensure proper ventilation for batteries that are in an enclosure. Never disconnect any charging unit circuit or battery circuit cable from the battery when the charging unit ts operating. A spark can cause the combustible gases to ignite. Do not smoke when batteries are serviced. 7405 Do not touch any part of an operating engine.

Allow the engine to cool before any maintenance is Always thaw a frozen battery before jump starting performed the battery. Frozen batteries can explode. on the engine. Relieve all pressure in the lubrication system, in the fuel system, or in the cooling system before any lines, fittings or related 101027886 items are disconnected. Fire Prevention and Explosion Prevention Coolant When the engine is at operating temperature, the engine coolant is hot. The coolant is also under pressure. The radiator and all lines to the heaters or to the engine contain hot coolant. When pressure is relieved rapidly, the hot coolant can turn into steam. SMCS Code:

1000; 7405 A flash fire may result in personal injury if the crankcase covers are removed within fifteen minutes after an emergency shutdown.