SEN01206-00 50 Disassembly and assembly 3. Install collar (7-2) and O-ring to shaft (6). 6. Install coupling (5) and holder (4), and tighten bolt (3). 3 Mounting bolt: 245.2 – 308.9 Nm {25 – 31.5 kgm} 4. Set cover (2) to shaft (6), and press fit bearing inner race (7-3) using tool F . 5. Install oil seals (8) and (9) to cover (2). 2 Press fitting surface of oil seal: Gasket sealant (LG-5) 2 Oil seal lip surface: Grease (G2-LI) a Apply gasket sealant at oil seal surface thinly, and wipe off extra sealant. 10 D155AX-6