30 Testing and adjusting SEN00679-01 Measuring engine speed 1 k Stop the machine on level ground, lower the work equipment to the ground, stop the engine, and set the parking brake lever and work equipment lock lever in the lock posi- tion. a Measure the engine speed under the following conditions. q Engine coolant temperature: Within oper- ating range q Power train oil temperature: Within operat- ing range q Hydraulic oil temperature: Within operat- ing range q Working mode: P mode 2. Measuring low idle speed 1) Start the engine and set the fuel control dial in the low idle (MIN) position.
2) Set the PCCS lever, blade control lever, and ripper control lever in neutral and measure the engine speed. a The parking brake lever and work equipment lock lever may be kept in the LOCK position. q Gearshift mode: Either Auto or Manual 1. Preparation work Measure the engine speed with the Adjustment function in the service mode of the machine monitor. a For the operating method of the machine monitor, see Special functions of machine monitor (EMMS). 1) Measuring low idle speed, decelerator pedal speed, auto-deceleration speed, torque converter stall speed, and torque converter stall speed + work equipment relief speed (full stall speed): 3.
Measuring high idle speed 1) Start the engine and set the fuel control dial in the high idle (MAX) position. 2) Set the PCCS lever, blade control lever, and ripper control lever in neutral and measure the engine speed. a The parking brake lever and work equipment lock lever may be kept in the LOCK position. a When measuring the high idle speed, be sure to select adjustment code [ 0007 ] (If adjustment code [ 0530 ] is selected, the auto-deceleration speed is measured). q Adjustment code: 0530 (Stall mode) a When stalling the torque converter for a purpose other than measuring the engine speed, be sure to use this adjustment code, too. 4.
Measuring decelerator pedal speed 1) Start the engine and set the fuel control dial in the high idle (MAX) position. 2) Set the PCCS lever, blade control lever, and ripper control lever in neutral, press the decelerator pedal to the stroke end, and measure the engine speed. a The parking brake lever and work equipment lock lever may be kept in the LOCK position. 2) Measuring high idle speed: q Adjustment code: 0007 (Reset engine deceleration) a Only when this code is selected, the engine can be operated and tested with the auto-decelerator reset. 5. Measuring auto-deceleration speed 1) Start the engine and set the fuel control dial in the high idle (MAX) position.
2) Set the PCCS lever, blade control lever, and ripper control lever in neutral and measure the engine speed. D155AX-6 5