Komatsu D155AX-6 — TESTING AND ADJUSTING ALTERNATOR BELT TENSION

30 Testing and adjusting SEN00679-01 Testing and adjusting alternator belt tension 1 6. Install belt cover (1) with the 2 mounting bolts. a Check for breakage of the pulleys, wear of the V-grooves, contact of the belts and V- grooves, and contact of the belt covers and rotating parts. a If the belt is lengthened to the adjustment limit, cut, or cracked, replace it with new one. a If the V-belt is replaced, adjust its tension again after 1 operating hour. a After tightening the bolts, check that the belt tension is normal according to the above procedure.

k Stop the machine on level ground, lower the work equipment to the ground, stop the engine, and set the parking brake lever and work equipment lock lever in the lock posi- tion. Testing 1. Open the engine right side cover and remove the inspection plate on the right of the radiator guard. 2. Press the intermediate point of the belt between alternator pulley and water pump pul- ley with a finger and measure deflection (a) of the belt. a Pressing force: Approx. 98 N {Approx. 10 kg} a Deflection (a): 13 – 16 mm 7. After testing and adjusting, return the removed parts. Adjusting a If the deflection is out of the standard range, adjust it according to the following procedure. 1.

Remove the 2 mounting bolts and belt cover (1). a Remove the belt cover only when replac- ing the belt. 2. Loosen 2 mounting bolts (3) of alternator (2), and then loosen lock bolt (4) of the adjustment rod. 3. Loosen locknut (5) of the adjustment rod and move alternator (2) with adjustment nut (6) to adjust the tension of the belt. 4. While fixing adjustment nut (6), tighten locknut (5). 5. Tighten locknut (4) of the adjustment rod and 2 mounting bolts (3) of alternator (2). D155AX-6 25