Komatsu D155AX-6 — ADJUSTING FUEL CONTROL DIAL AND DECELERATOR PEDAL

30 Testing and adjusting SEN00679-01 2. Preparation work 1) Remove the right cover of the dashboard and the right foot rest as a unit. 2) Start the engine and set the machine mon- itor to Adjusting function of the service mode. 5. Work after adjustment After finishing all adjustment, return the removed parts. q Adjustment code: 0007 (Engine decelerator cut) a For the operating method, see "Spe- cial functions of machine monitor (EMMS)". 3. Adjusting decelerator pedal speed With the fuel control dial in the high idle posi- tion (MAX), press decelerator pedal (1) to stop- per bolt (2) and check that the decelerator pedal speed is normal. q Decelerator pedal speed:

875 ± 50 rpm a If the decelerator pedal speed is abnor- mal, adjust installed dimension (a) of stop- per bolt (2). q Standard installed dimension a) of stopper bolt: 35.0 mm 4. Adjusting high idle speed With the fuel control dial in the high idle posi- tion (MAX), release decelerator pedal (1) and check that the high idle speed is normal. q High idle speed: 2,050 ± 50 rpm a If the high idle speed is abnormal, adjust it according to the following procedure. q When the engine speed is above 1,950 rpm: Lower the engine speed below 1,900 rpm temporarily with stopper bolt (3) to elimi- nate the play of the decelerator pedal, and then adjust the engine speed to the high idle.

q When the engine speed is below 1,950 rpm: Adjust the engine speed to the high idle speed with stopper bolt (3). q Standard installed dimension (b) of stop- per bolt: 34.8 mm D155AX-6 31