Komatsu D155AX-6 — MEASURING POWER TRAIN OIL PRESSURE

30 Testing and adjusting SEN00680-01 3. Measuring torque converter stator clutch pressure (SC) 1) Connect oil pressure gauge [1] of hydrau- lic tester M to oil pressure pickup plug (3). a When using an analog oil pressure gauge, use one of 5.9 MPa {60 kg/ cmІ}. 5) Set the PCCS lever in the forward position to run the track shoe idle. k Take care not to get caught in a rotating part of the track shoe dur- ing measurement. a Keep the steering system in neutral. 6) While running the engine at high idle, when L/U Fill Sw in the monitoring item is turned ON, measure the lockup clutch pressure. 2) Start the engine and set the PCCS lever in the fully neutral position.

a The parking brake lever may be set in the LOCK position. 3) While running the engine at low idle and high idle, measure the stator clutch pres- sure. 7) After finishing measurement, remove the measuring instruments and return the removed parts. 4) After finishing measurement, remove the measuring instruments and return the removed parts. D155AX-6 5