SEN00681-01 30 Testing and adjusting t Service mode To change the operator mode to the service mode, perform the following operation. This operation is always required when you use the service mode. a The items which can be selected in the service menu are as follows. 1. Check of display of screen and operation of switches While the ordinary screen is displayed, perform the following operation with the numeral input switches. q Operation of switches (While pressing [4], perform the operation in order): [4] + [1] o [2] o [3] a This operation of the switches is accepted only while the ordinary screen is dis- played. 2.
Selection of service menu When the "Service Menu" screen is displayed, the service mode is selected. Select a service menu you use with the function switches or numeral input switches. a Items with 2-digit codes are the menus dis- played on the Service menu screen. The items on their right are the menus on the next hierar- chy. q [F3]: Move to lower menu q [F4]: Move to upper menu q [F5]: Return to ordinary screen (operator mode) q [F6]: Confirm selection a You may enter a 2-digit code with the numeral input switches to select the menu of that code and confirm it with [F6].
16 D155AX-6 01 Monitoring 02 Abnormality Record Mechanical system "Abnormality Record" Electrical system "Abnormality Record" Air conditioner "Abnormality Record"/ Heater "Abnormality Record" 03 Maintenance Record 04 Maintenance Mode Change 05 Phone Number Entry 06 Default Key-on Mode Setting of unit Setting of maintenance password Setting of camera Setting of ECO display 07 Adjustment 08 PM CLINIC 09 Cylinder Cut-Out 10 No Injection 11 Fuel Consumption Terminal Status 12 KOMTRAX GPS & Communication Status Settings Modem S/N GPS & Communication Status Modem S/N 13 Service Message