30 Testing and adjusting SEN00681-01 Adjustment ID: 2022 (Work equipment controller voltage check mode) Adjustment ID: 2222 (HSS min. current setting mode) q This adjustment code is used to check the con- stant power supply voltage and switch power supply voltage applied to the work equipment controller. a Use this adjustment code for testing, adjusting, or troubleshooting when necessary. q This adjustment code is used to adjust the turning radius to start steering the machine when the steering feel is different by the steer- ing direction. a Use this adjustment code for work when nec- essary. q Functions of function switches [F3]: Unused [F4]: Unused [F5]:
Return to adjustment item selecting screen (ID inputting screen) [F6]: Unused q Functions of function switches [F3]: Unused [F4]: Unused [F5]: Return to adjustment item selecting screen (ID inputting screen) [F6]: Save adjustment value q Information displayed on screen [WE CONTROLLER UNSWITCH POWER]: Constant power supply voltage [WE CONTROLLER ACC POWER]: Switch power supply voltage q Operating method 1) Set the parking brake lever in the free position. 2) Tilt the PCCS lever to a right or left posi- tion at which the current to be set is indi- cated and hold it at that position. q Operating method:
When this adjustment code is displayed, its function is effective and the constant power supply voltage and switch power supply volt- age are displayed simultaneously. a After this adjustment code is turned OFF, its function is ineffective. q If the lever is tilted to the left, the cur- rent becomes negative. q If the lever is tilted to the right, the current becomes positive. 3) Press [F6] and check that the alarm buzz- er sounds. a The current (mA) varies in the range from -350 (left end) to 350 (right end). a As the set current is increased in the posi- tive or negative direction, the turning radius to start steering is reduced more (the machine is steered more quickly).
a It is not necessary to steer the machine during adjustment. After finishing adjust- ment, however, steer the machine and check that there is not a problem in the actual steering feel. a The following figure shows an example of reducing the set current for the left steer- ing to increase the turning radius. D155AX-6 55