30 Testing and adjusting SEN00682-01 Preparation work for troubleshooting of electrical system 1 2. Engine controller 1) Open the left engine side cover and left mudguard. 2) Remove the mounting bolts and cover (6). a When carrying out troubleshooting of an elec- tric circuit related to the machine monitor, engine controller, power train controller, or work equipment controller, expose the related con- nectors according to the following procedure. 1. Machine monitor 1) Remove the 4 mounting bolts each from covers (1) and (2) and remove those cov- ers. 2) Remove the 4 mounting bolts each from covers (3) and (4) and remove those cov- ers together with the foot rest.
a The 2 bolts on the front window side of the foot rest are used as the cover mounting bolts, too. 3) Remove the 4 mounting bolts of machine monitor (5) and pull out machine monitor (5) and switch cover together toward the operator's seat. 3) Insert or connect troubleshooting T-adapt- ers in or to connectors EGC1 , EGC2 , and EGC3 of engine controller (7). a Since connectors EGC1 and EGC2 are fixed with screws, loosen those screws before disconnecting. a When returning connectors EGC1 and EGC2 , tighten the screws to the specified torque. 3 Screw: 3 ± 1 Nm {0.3 ± 0.1 kgm} 4) Insert or connect troubleshooting T-adapt- ers in or to connectors CM01 , CM02 , and CM03 of machine monitor (5).
a AT11 is for the GPS antenna. a If a camera is installed, CM05 is also wired. D155AX-6 3