SEN00718-01 40 Troubleshooting Failure code [DB90KK] WE controller: Source voltage reduction 1 60 D155AX-6 Action code Failure code Trouble WE controller: Source voltage reduction (Work equipment controller system) E04 DB90KK Contents of trouble • Source voltage of work equipment controller is below 17 V. Action of controller • Limits operation of engine and transmission. Problem that appears on machine • Machine monitor may not display normally. • Relays and solenoids may not be driven and system may not operate normally. • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, it cannot travel at all.
Related information • Source voltage of work equipment controller can be checked with adjusting function. (Code: 2022) • Method of reproducing failure code: Turn starting switch ON. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective circuit breaker (CB2, CB7, CB30 or CB105) If circuit breaker is turned OFF, circuit probably has ground fault (See cause 3). 2 Disconnection in wiring har- ness (Disconnection in wiring or defective contact in con- nector) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.
Wiring harness between WEC3 (female) (1), (11) – CB7 (2) Resis- tance Max. 1 z Wiring harness between CB7 (1) – CB30 (B30S) Resis- tance Max. 1 z Wiring harness between CB30 (B30L) – ter- minal BRB Resis- tance Max. 1 z Wiring harness between WEC3 (female) (2), (12), (22) – CB2 (2) Resis- tance Max. 1 z Wiring harness between CB2 (1) – CB105 (B105S) Resis- tance Max. 1 z Wiring harness between CB105 (B105L) – terminal BRC Resis- tance Max. 1 z Wiring harness between WEC3 (female) (21), (31), (32), (33) – chassis ground (GND11) Resis- tance Max.
1 z 3 Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between WEC3 (female) (1), (11) – CB7 (2) or circuit branch end and chassis ground Resis- tance Min. 1 Mz Wiring harness between CB7 (1) – CB30 (B30S) or circuit branch end and chassis ground Resis- tance Min. 1 Mz Wiring harness between CB30 (B30L) – ter- minal BRB and chassis ground Resis- tance Min. 1 Mz Wiring harness between WEC3 (female) (2), (12), (22) – CB2 (2) or WEPW (female) (A) and chassis ground Resis- tance Min.
1 Mz Wiring harness between CB2 (1) – CB105 (B105S) or circuit branch end and chassis ground Resis- tance Min. 1 Mz Wiring harness between CB105 (B105L) – terminal BRC and chassis ground Resis- tance Min. 1 Mz