SEN00719-01 40 Troubleshooting Failure code [DB95KK] WE controller: Source voltage reduction 1 4 D155AX-6 Action code Failure code Trouble WE controller: Source voltage reduction (Work equipment controller system) E03 DB95KK Contents of trouble • Voltage of 5V power supply circuit for work equipment controller sensors is below 4.5 V or above 5.5 V. • Abnormal current flowed in 5V power supply circuit for work equipment controller sensors. Action of controller • Turns output of 5V power supply circuit OFF, if abnormal current flows. • Limits operation of engine and transmission. Problem that appears on machine • System may not operate normally.
• Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1. Related information • Method of reproducing failure code: Turn starting switch ON. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective work equipment pump oil pressure sensor (Internal trouble) a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Disconnect devices at right in order. If "E" of failure code disappears when a device is discon- nected, that device has trouble in it.
Work equipment pump oil pressure sensor Connector HHP 2 Ground fault in wiring har- ness (Contact with GND cir- cuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between WEC3 (female) (34) – HHP (female) (B) and chassis ground Resis- tance Min. 1 Mz 3 Hot short (Short circuit with 24V circuit) in wiring harness a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Wiring harness between WEC3 (female) (34) – HHP (female) (B) and chassis ground Voltage Max.
1 V 4 Defective work equipment controller a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. WEC1, WEC3 Voltage Between WEC3 (34) – WEC1 (21) 4.5 – 5.5 V