SEN00722-01 40 Troubleshooting Failure code [DXH7KB] R clutch ECMV: Short circuit 1 Circuit diagram related to transmission R clutch ECMV 12 D155AX-6 Action code Failure code DXH7KB Trouble ( R clutch ECMV: Short circuit Power train controller system) E03 Contents of trouble • When signal was output to transmission R clutch ECMV solenoid circuit, abnormal current flowed. Action of controller • Turns signal to transmission R clutch ECMV solenoid circuit OFF. • Limits operation of engine and transmission. Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1.
Related information • Output to R clutch ECMV solenoid can be checked with monitoring function. (Code: 31616 T/M Clutch R ECMV (F/B)) • Method of reproducing failure code: Start engine + Set gear to R (Reverse). Possible cause and standard value in norma state Cause Defective R clutch ECMV 1 solenoid (Internal short cir- cuit) s Ground fault in wiring har- 2 ness (Contact with GND cir- l cuit) Short circuit in wiring har- 3 ness (with another wiring harness) ( I Defective power train con- 4 troller Standard value in normal state/Remarks on troubleshooting a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.
SRT (male) Resistance Between (1) – (2) 3.5 – 12.5 z Between (1) – chassis groun d Min. 1 Mz a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between STC3 (female) (37) – SRT (female) (1) and chassis ground Resis- M tance in. 1 Mz a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between STC3 (female) (37) – SRT (female) (1) and between STC3 female) (13) – SRT (female) (2) Resis- M tance in. 1 Mz f causes 1 - 3 are not detected, power train controller may be defective. (Since trouble is in system, troubleshooting cannot be carried out.)