Komatsu D155AX-6 — FAILURE CODE [DXH7KA] R CLUTCH ECMV: DISCONNECTION

40 Troubleshooting SEN00722-01 Failure code [DXH7KA] R clutch ECMV: Disconnection 1 Circuit diagram related to transmission R clutch ECMV D155AX-6 11 Action code Failure code DXH7KA Trouble ( R clutch ECMV: Disconnection Power train controller system) E03 Contents of trouble • When signal is output to transmission R clutch ECMV solenoid circuit, no current flows. Action of controller • Turns signal to transmission R clutch ECMV solenoid circuit OFF. • Limits operation of engine and transmission. Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1.

Related information • Output to R clutch ECMV solenoid can be checked with monitoring function. (Code: 31616 T/M Clutch R ECMV (F/B)) • Method of reproducing failure code: Start engine + Set gear to R (Reverse). Possible cause and standard value in norma state Cause Defective R clutch ECMV 1 solenoid (Internal disconnec- tion) Disconnection in wiring har- ness (Disconnection in wiring s 2 or defective contact in con- nector) l Hot short (Short circuit with 3 24V circuit) in wiring harness I Defective power train con- 4 troller Standard value in normal state/Remarks on troubleshooting a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.

SRT (male) Resistance Between (1) – (2) 3.5 – 12.5 z a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. Wiring harness between STC3 (female) (37) – SRT (female) (1) Resis- tance Max. 1 z Wiring harness between STC3 (female) (13) – SRT (female) (2) Resis- tance Max. 1 z a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting. Wiring harness between STC3 (female) (13) – SRT (female) (2) or circuit branch end and chassis ground Voltage Max. 1 V f causes 1 – 3 are not detected, power train controller may be defective. (Since trouble is in system, troubleshooting cannot be carried out.)