40 Troubleshooting SEN00722-01 Failure code [DXH8KB] F clutch ECMV: Short circuit 1 Circuit diagram related to transmission F clutch ECMV D155AX-6 15 Action code Failure code DXH8KB F Trouble ( clutch ECMV: Short circuit Power train controller system) E03 Contents of trouble • When signal was output to transmission F clutch ECMV solenoid circuit, abnormal current flowed. Action of controller • Turns signal to transmission F clutch ECMV solenoid circuit OFF. • Limits operation of engine and transmission. Problem that appears on machine • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to R1.
Related information • Output to F clutch ECMV solenoid can be checked with monitoring function. (Code: 31622 T/M Clutch F ECMV (F/B)) • Method of reproducing failure code: Start engine + Set gear to F (Forward). Possible cause and standard value in norma state Cause a Defective F clutch ECMV 1 solenoid (Internal short cir- cuit) a s Ground fault in wiring har- 2 ness (Contact with GND cir- W l cuit) – a Short circuit in wiring har- 3 ness (with another wiring W harness) – (f If Defective power train con- 4 d troller c Standard value in normal state/Remarks on troubleshooting Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON.
SFT (male) Resistance Between (1) – (2) 3.5 – 12.5 z Between (1) – chassis groun d Min. 1 Mz Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. iring harness between STC3 (female) (27) SFT (female) (1) and chassis ground Resis- M tance in. 1 Mz Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. iring harness between STC3 (female) (27) SFT (female) (1) and between STC3 emale) (13) – SFT (female) (2) Resis- M tance in. 1 Mz causes 1 – 3 are not detected, power train controller may be efective. (Since trouble is in system, troubleshooting cannot be arried out.)