Komatsu D155AX-6 — FAILURE CODE [DXJ9KY] BLADE RIGHT 2 EPC: SHORT CIRCUIT

40 Troubleshooting SEN00723-01 Failure code [DXJ9KY] Blade right 2 EPC: Short circuit 1 Circuit diagram related to blade tilt left head EPC solenoid D155AX-6 7 Action co de Failure code Trouble Blade right 2 EPC: Short circuit (Work equipment controller system) E03 DXJ9KY Contents trouble of • When signal was output to blade tilt left head EPC solenoid circuit, abnormal current flowed. Action o controll f • Turns signal to blade tilt left head EPC solenoid circuit OFF. er • Limits operation of engine and transmission. Problem t appears machin hat • Blade tilt cylinder or pitch left cylinder cannot be retracted. on • Once machine is stopped, engine speed is limited to medium (half).

e • Once machine is stopped, travel is limited to R1. Relate informati • Output to blade tilt left head EPC solenoid can be checked with monitoring function. d (Code: 71005 Blade Tilt LH-H EPC (F/B)) on • Method of reproducing failure code: Turn starting switch ON + Operate blade control lever (Pitch back).

Possible ca and stand value in no state Cause Defective blade tilt left head 1 EPC solenoid (Internal short circuit) uses ard Hot short in wiring harness rmal 2 (Contact with GND circuit) Defective work equipment 3 controller Standard value in normal state/Remarks on troubleshooting Defective blade tilt left head EPC solenoid (Internal short circuit) a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. WEP3 (male) Resistance Between (1) – (2) 2 – 12 z Between (1) – chassis ground Min. 1 Mz Hot short in wiring harness (Contact with GND circuit) a Prepare with starting switch OFF, then turn starting switch ON and carry out troubleshooting.

Wiring harness between WEC3 (female) (28) – WEP3 (female) (1) and chassis ground Voltage Ma x. 1 V Defective work equipment controller a Prepare with starting switch OFF, then carry out troubleshoot- ing without turning starting switch ON. WEC3 (female) Resistance Between (28) – (13) 2 – 12 z Between (28) – chassis ground Min. 1 Mz