10 Structure, function and maintenance standard SEN00604-00 Power transmitting route When lockup clutch is“disengaged“and stator clutch is “engaged“ When lockup clutch is“engaged“and stator clutch is “disengaged“ q If lockup clutch (3) is “disengaged“, drive case (5) and turbine (7) are disconnected from each other. If stator clutch (9) is “engaged“ at this time, torque converter case (10) and stator shaft (11) are connected to each other to fix stator (8). Therefore, the torque converter works as an ordinary torque converter. q If lockup clutch (3) is “engaged“, drive case (5) and turbine (7) are connected to each other.
If stator clutch (9) is “disengaged“ at this time, torque converter case (10) and stator shaft (11) are disconnected from each other, and stator (8) is dragged and turned by pump (6) and tur- bine (7). Therefore, the torque converter works as a lockup torque converter. q The power from the engine is transmitted to coupling (1) through the damper and the uni- versal joint. q The power from the engine is transmitted to coupling (1) through the damper and the uni- versal joint. q The power transferred to coupling (1) rotates input shaft (2), clutch housing (4), drive case (5) and pump (6) integrally.
q The power transferred to coupling (1) rotates input shaft (2), clutch housing (4), drive case (5) and pump (6) integrally. q The power transferred to pump (6) rotates tur- bine (7) through the medium of oil and is trans- ferred to transmission input shaft (12) attached to turbine (7) with spline. q The power transferred to drive case (5) rotates turbine (7) directly since lockup clutch (3) is fixed, and is transferred to transmission input shaft (12) attached to turbine (7) with spline. D155AX-6 17