Komatsu — SELF-DIAGNOSTIC FUNCTION

OPERATION PRECAUTIONS WHEN USING AIR CONDITIONER When running the air conditioner, always start with the engine running at low speed. Never start the air conditioner when the engine is running at high speed. It will cause failure of the air conditioner. If water gets into the control panel or sunlight sensor, it may lead to unexpected failure, so be careful not to let water get on these parts. In addition, never bring any flame near these parts. For the auto function of the air conditioner to work properly, always keep the sunlight sensor clean and do not leave anything around the sunlight sensor that may interfere with its sensor function.

Ventilate the cab from time to time when using the cooler. If you smoke when the cooler is on, the smoke may start to hurt your eyes, so open the window and carry out ventilation and cooling for a short time to remove the smoke. When running the air conditioner for a long time, carry out ventilation and cooling together once each hour. Be careful not to let the temperature in the cab get too low. When the cooler is on, set the temperature so that it feels slightly cool when entering the cab 5 - 6єC (41 - 43°F) lower than the outside temperature). This temperature difference is considered to be the most suitable for your health. Adjust the temperature properly.

MAINTAIN MACHINE EQUIPPED WITH AIR CONDITIONER When carrying out inspection of a machine equipped with an air conditioner, see “CHECK AND ADJUST AIR CONDI- TIONER” on page 3-38 and carry out inspection according to the table. SELF-DIAGNOSTIC FUNCTION It is possible to carry out troubleshooting of the various sensors and equipment used on the air conditioner. 1. Turn the ignition switch to the “ON” position 2. Press OFF switch (1). The temperature setting and air flow display on the liquid crystal display portion go out and operation stops. PC300LC/HD-7E0 2-63