Komatsu — WALK-AROUND CHECKS

OPERATION PRECAUTIONS BEFORE STARTING WORK OPERATIONS Before starting your work operations it is important to perform several procedures to be sure your equipment is in a safe operating condition. It is also important to be aware of the hazards involved when operating your machine. PRE-OPERATIONAL CHECKS Before starting your machine and preceding with any work operations it is important to be sure your machine is safe to operate. Below is a list of some basic items to check before any work is to begin. If any problems are found during your Pre-operational Check, have them repaired immediately. Never operate a machine that is unsafe, damaged or in need of repair.

WALK-AROUND CHECKS Before starting the engine, look around the machine and under the machine to check for loose nuts or bolts, or leakage of oil, fuel, or coolant, and check the condition of the work equipment and hydraulic system. Check for loose wiring, play, and accumulation of dust at places which reach high temperatures. Remove any flammable materials from around the battery or engine muffler, or other high temperature engine parts. Leakage of fuel or oil will cause the machine to catch fire. Check carefully, and be sure to repair any abnormalities, or please contact your Komatsu distributor. Always check the items in this section before starting the engine each day. 1.

Check for damage, wear, play in work equipment, cylinders, linkage, hoses Check to be sure there are no cracks, excessive wear, or play in the work equipment, cylinders, linkage, or hoses. If any abnormality is found, repair it. 2. Remove dirt and dust from around engine, battery, radiator Check if there is any dirt or dust accumulated around the engine or radiator. Check also if there is any flammable material (dead leaves, twigs, grass, etc.) accumulated around the battery or high temperature engine parts, such as the engine muffler or turbocharger. Remove all such dirt or flammable material. 3.

Check for leakage of coolant or oil around engine Check to be sure there is no leakage of oil from the engine or leakage of coolant from the cooling system. If any abnor- mality is found, repair it. 4. Check for oil leakage from hydraulic equipment, hydraulic tank, hoses, joints Check to be sure there is no oil leakage. If any abnormality is found, repair the place where the oil is leaking. 5. Check the undercarriage (track, sprocket, idler, guard) for damage, wear, loose bolts, or leakage of oil from rollers 6. Check for damage to the handrail, loose bolts 7. Check for damage to gauges, monitor, loose bolts Repair any damage and tighten any loose bolts.

Check to be sure there is no damage to the gauges and monitor in the operator's cab. If any abnormality is found, replace the parts. Clean off any dirt on the surface. 8. Clean rear view mirror, check for damage Check to be sure there is no damage to the rear view mirror. If it is damaged, replace it with a new mirror. Clean the sur- face of the mirror and adjust the angle so that the view to the rear can be seen from the operator’s seat. 9. Seat belt and mounting clamps Check to be sure there is no abnormality in the seat belt or mounting clamps. If there is any damage, replace with new parts. 10. Check bucket with hook (if equipped) for damage.

Check the hook, catcher and hook foot for damage. If damage is found, contact your Komatsu distributor for repair. PC300LC/HD-7E0 2-73