CHECK AND DRAIN WATER SEPARATOR OPERATION 1. Open the cover on the right side of the machine. 2. The water separator forms one unit with fuel pre-filter (1). 3. It is possible to judge the water level and amount of sediment by looking through transparent cap (2). If there is any water or sediment collected at the bottom, set a container to catch the drain water under drain hose (3). 4. Loosen drain valve (4) and drain the water. 5. When fuel starts to drain from drain hose (3), tighten drain valve (4) immediately. On this machine, a sensor is installed to detect if water is accumulated in transparent cap (2).
When the water separator monitor (5) lights up red on the machine monitor, it indicates that water is accumulated in transparent cap (2). In this case also, use the procedure above to drain the water. If the water accumulated in transparent cap (2) freezes, the water separator monitor may not light up. After the engine is started, as the temperature around fuel pre-filter (1) increases, the frozen water will melt and the water separator monitor may suddenly light up. In cold areas, even if the water separator monitor does not light up, drain the water frequently.
If the water inside transparent cap (2) freezes, check to be sure the frozen water has melted completely, then use the procedure above to drain the water. Remark If transparent cap (2) is dirty and the contents cannot be easily seen, clean transparent cap (2) when replacing fuel pre-filter cartridge (1). ADJUSTMENT OF DRAIN VALVE If drain valve (4) is stiff, coat the O-ring portion of the drain valve with grease to make the movement smooth. 1. Turn valve (5) at the bottom of the fuel tank to the right to close it. 2. Set a fuel container under transparent cap (2), then remove drain valve (4). PC300LC/HD-7E0 2-75