Komatsu — CHECKS BEFORE STARTING

OPERATION 3. Coat O-ring portion (5) with a suitable amount of grease. When doing this, be careful not to let the grease get stuck to the drain valve water drain port (6) or drain valve thread (7). 4. Screw drain valve (4) into transparent cap (2). 5. Remove the fuel container. 6. Turn valve (5) at the bottom of the fuel tank to the left to open it. CHECK AND ADDING OIL TO HYDRAULIC TANK The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. 1.

Set the work equipment in the posture shown in the diagram on the right, then check the oil level and add oil if necessary. 2. If the work equipment is not in the condition shown in the diagram on the right, start the engine, run the engine at low speed, retract the arm and bucket cylinder rods fully, then lower the boom, set the bucket teeth in contact with the ground, and stop the engine. 3. Within 15 seconds after stopping the engine, move each control lever (for work equipment and travel) to the full stroke in all directions to release the internal pressure. 4. Check sight gauge (G). The oil level should be between the H and L marks. 5.

If the level is below the L mark, add oil through oil filler (F) at the top of the hydraulic tank. Remark The oil level will vary depending upon the oil temperature. Accordingly, use the following as a guide: Before starting operation: Between H and L levels (Oil temperature 10 to 30 o C (50 to 86 o F)) Normal operation: Around H level (Oil temperature 50 to 80 o C (122 to 176 o F)) 2-76 PC300LC/HD-7E0