Do not add oil above the H line. This will damage the hydraulic circuit or cause the oil to spurt out. OPERATION If oil has been refilled, exceeding the H level, swing the upper structure until drain plug (P) beneath the hydraulic tank comes between the right and left track shoes and stop the engine. Wait for the oil to cool down sufficiently, then remove cover (1) and drain the excess oil through drain plug (P). CHECK AND ADD ENGINE OIL Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before checking oil. 1. Open the engine hood on the machine. 2.
Remove dipstick (G), and wipe the oil off with a cloth. 3. Fully insert dipstick (G) into filler pipe (F), then remove it. 4. The oil level should be between the (H) and (L) marks on dipstick (G). If the oil level is below the (L) mark, add oil through oil filler (F). 5. If the oil is above the (H) mark on the gauge, remove cover (1), drain the excess oil from drain valve (P) at the bottom of the engine oil pan, then check the oil level again. 6. If oil level is correct, securely tighten the oil filler cap and close the engine hood. Remark When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking.
If the machine is at an angle, make it horizontal before checking. PC300LC/HD-7E0 2-77