Komatsu — CHECKS BEFORE STARTING

OPERATION CHECK ELECTRICAL WIRING If fuses are frequently blown or if there are traces of short-circuiting in the electrical wiring, contact your Komatsu distributor to locate the cause and make the repair. Keep the top surface of the battery clean and check the vent hole in the battery cap. If it is clogged with dirt or dust, wash the battery cap to clear the vent hole. Check that there is no damage to the fuses; that fuses of the specified capacity are used; that there is no disconnection or trace of short-circuiting in the electric wiring and no damage to the covering.Check for loosened terminals. If found, tighten them.

Pay particular attention to the electric wiring when checking the battery, engine starting motor and alternator. Be sure to check to be sure there is no flammable material accumulated around the battery. If any is found, remove immediately. CHECK OR ADD FUEL When adding fuel, never spill the fuel or let it overflow. If any fuel has spilled, wipe it up immediately. If fuel has spilled over soil or sand, remove that soil or sand. Fuel is highly flammable and dangerous. Never bring flames near fuel. 1. Turn the engine ignition switch to the ON position and check the fuel level gauge (1) on the monitor panel for fuel level. After checking, turn the switch back to the OFF position. 2.

If fuel is found to be low, unscrew fuel filler cap (F) on the fuel tank and add fuel through the filler port until float gauge (G) comes up to the highest point. Fuel tank capacity: 605 liters (159.84 US gal) Position of tip (a) of float gauge (G) when fuel tank is full: 50 mm (2 in) 3. After adding fuel, push float gauge (G) straight down with fuel filler cap (F). 4. Be careful not to get float gauge (G) caught in the tab of fuel filler cap (F), and tighten fuel filler cap (F) securely. 2-78 PC300LC/HD-7E0