OPERATION ADJUSTMENTS BEFORE OPERATION Adjust the seat position before starting operations or after changing the operator. Adjust the seat so that the control levers and switches can be operated freely and easily with the operator’s back against the backrest. A: Fore and aft adjustment Pull lever (1) up, set the seat to the desired position, then release the lever. Fore and aft adjustment160 mm in 16 stages B: Adjusting reclining Remark The seat can be reclined to a large angle when the seat is pushed fully forward. However, the reclining angle is reduced when the seat is moved back. So when moving the seat to the rear, return the seat back to its upright position.
Pull lever (2) and set the seat back to a position which is comfortable for operation, then release the lever. Sit with your back against the seat back when adjusting. If your back is not touching the seat back, the seat back may suddenly move forward. C: Adjusting seat tilt 1. Forward tilt; Push lever (3) up to adjust the angle of the front of the seat. (4 stages) A. To raise the angle at the front of the seat, keep the lever pushed up and apply your weight to the rear of the seat. 2. Rear tilt; Pull lever (4) up to adjust the angle of the rear of the seat. (4 stages) B. To lower the angle at the front of the seat, keep the lever pushed up and apply your weight to the front of the seat. A.
To raise the angle at the rear of the seat, keep the lever (3) pulled up and stand up slightly to remove your weight from the seat. B. To lower the angle at the rear of the seat, keep the lever (3) pulled up and apply your weight to the rear of the seat. Amount of tilt................................................. Up 13° down 13° 3. Adjusting seat height; You can move the seat up or down by combining adjustments 1 and 2. After setting the for- ward tilt or rear tilt to the desired height, set the other to make the seat horizontal. Release the lever to secure the adjustment. Height adjustment...........................................................60 mm D:
Adjusting armrest angle Armrest (5) can be made to spring up by hand approximately 90°. To make fine vertical adjustments of the armrest angle, turn the bottom (6) of the armrest by hand. Armrest adjustment angle ........................................................... 25° If the seat back is tipped to the front without raising the armrest (5), the armrest will rise automatically. 2-80 PC300LC/HD-7E0