2. Set fuel control dial (2) at the low idling (MIN) position. If it is at the high idling (MAX) position, always change it to the low idling (MIN) position. OPERATION 3. Turn the key in ignition switch (3) to ON position (B). If the ambient temperature is low, the preheating monitor lights up and automatic preheating is carried out. Keep the key in ignition switch (3) at the ON position until the preheating monitor goes out. The time that the preheating monitor stays lit up depends on the ambient temperature as shown in the table on the right. 4.
If the preheating monitor does not light up, or it lights up and then goes out to inform that the engine preheating has been completed, turn the key in ignition switch (3) to the START position (C) and start the engine. Remark If the ambient temperature is low, the engine may not start even when the key in the ignition switch (3) is kept at the START position for 20 seconds. If this happens, wait for at least 2 minutes, then start again from the beginning. 5. After the engine starts, release the key in ignition switch (3). The key will automatically return to the ON position (B).
PC300LC/HD-7E0 2-87 Ambient temperature The time that the preheating monitor is lit u -10oC (14oF) 15 seconds -20oC (-4oF) 32 seconds -25oC(-13oF) 40 seconds