Komatsu — ESCAPING FROM MUD

2. When traveling up a steep hill of more than 15 o , set the work equipment to the posture shown in the diagram on the right. OPERATION 3. When traveling up a steep slope, extend the work equipment to the front to improve the balance, keep the work equipment approximately 20 to 30 cm (8 to 12 in) above the ground, and travel at low speed. TRAVELING DOWNHILL To brake the machine during downhill runs, put the travel lever in the neutral position. This will cause the brake to be automatically applied. ENGINE STOPPED ON SLOPE If the engine stops when traveling uphill, move all the levers to the neutral position, lower the bucket to the ground then start the engine again.

PRECAUTIONS ON SLOPES If the engine stops when the machine is on a slope, never use the left work equipment control lever to carry out swing opera- tions. The upper structure will swing under its own weight. Be extremely careful when opening or closing the door on slopes. The weight of the door may cause the door to open or close suddenly. Always set the door so that it is firmly locked in position, open or closed. ESCAPING FROM MUD Always operate carefully to avoid getting stuck in mud. If the machine does get stuck in mud, do as follows to get the machine out. Place the machine push-up switch in the high-pressure set position (b). This will increase the push power of the boom.

PC300LC/HD-7E0 2-103