Komatsu — MOVING MACHINE BACKWARD

OPERATION ONE SIDE OF TRACK STUCK When using the boom or arm to raise the machine, always have the bottom of the bucket in contact with the ground. (Never push with the teeth). The angle between the boom and arm should be 90є to 110є. The same applies when using the inverting bucket. When only one side is stuck in mud, use the bucket to raise the track, then lay boards or logs and drive the machine out. If necessary, also put a board under the bucket. BOTH SIDES OF TRACKS STUCK If the tracks on both sides are stuck in mud and the machine slips and cannot move, use the procedure given above to lay logs or timber.

Dig the bucket into the ground at the front, operate the arm in the same way as when digging, and set the travel lever to FORWARD to pull the machine out. MOVING MACHINE BACKWARD 1. Set lock lever (4) in the FREE position (F), fold the work equipment, and raise it 40 to 50 cm (16 to 20 in) from the ground. 2. Operate the right and left travel levers (5), or the right or left travel pedals (6) as follows: When sprocket (A) is at the rear of the machine: Slowly pull the levers (5) backward, or slowly depress the rear part of the pedals (6) to move the machine backward. When sprocket (A) is at the front of the machine:

Slowly push the levers (5) forward, or slowly depress the front part of the pedals (6) to move the machine backward. 3. Check that the travel alarm sounds properly. If the travel alarm does not sound, please contact your Komatsu distributor for repair. Remark In cold temperatures, if the machine travel speed is not normal, thoroughly perform the warming-up operation. In addition, if the undercarriage is clogged with mud and the machine travel speed is not normal, remove the soil and mud from the undercarriage. 2-104 PC300LC/HD-7E0