OPERATION WORK EQUIPMENT OVERVIEW If the lever is operated when the engine speed has been lowered by the auto-deceleration function, the engine speed will suddenly rise, operate the levers carefully. Use the control levers to operate the work equipment. Note that when the levers are released, they return to the HOLD position and the work equipment is held in that position. ARM CONTROL Move the left work equipment control lever to the front or rear to operate the arm in or out. SWING CONTROL Move the left work equipment control lever to the left or right to swing the upper structure. BOOM CONTROL Move the right work equipment control lever to the front or rear to operate the boom up or down.
BUCKET CONTROL Move the right work equipment control lever to the left or right to operate the bucket dump or curl. If the work equipment control levers are returned to the neutral position when the machine is stopped, even if the fuel control dial is set to FULL, the auto-deceleration mechanism will act to reduce the engine speed to a mid-range speed. The control circuit on this machine is equipped with an accumulator. Even if the engine is stopped, if the ignition switch key is turned to the ON position within 15 seconds after stopping the engine, and the lock lever is set to the FREE position, it is possible to use the control lever operation to lower the work equipment to the ground.
This procedure can also be used for releasing the remaining pressure in the hydraulic cylinder circuits or for lowering the boom after loading the machine onto a trailer. PC300LC/HD-7E0 2-115