OPERATION OPERATING MODES WORKING MODE By using the working mode selector switch to select a working mode that matches the operating condition, it is possible to carry out operations efficiently. Use the following procedure to make effective use of each working mode. When the ignition switch is turned ON, the working mode is set to P mode (digging). Use the working mode switch to set the most efficient mode to match the type of work. Remark If breaker operations are carried out in the heavy digging mode, the hydraulic equipment may be damaged. Operate the breaker only in B mode. ONE-TOUCH POWER MAX. SWITCH The one-touch power max. switch can be used during operations to increase the power.
Make effective use of this function whenever necessary in combination with the working mode. 1. Press the left knob switch and keep it pressed. The power is increased for up to 8.5 seconds, while the switch is being pressed. The increased power is automatically canceled after 8.5 seconds. This function is not actuated when the working mode is set to L mode or B mode. 2-116 PC300LC/HD-7E0 Working mode Applicable operations P mode Normal digging, loading operations (Operations with emphasis on productivity) E mode Normal digging, loading operations L mode When positioning work equipment exactly (fine-control operations) B mode Breaker operations