Komatsu — SEVERE JOB CONDITIONS

OPERATION WORK EQUIPMENT ANGLES An excavator is suitable for excavating at a position lower than the machine. When the condition of the machine is as shown, each cylinder's maximum pushing excavation force is obtained when the bucket cylinder and link, arm cylinder and arm are at 90є. When excavating, use this angle to effectively optimize your work efficiency. The range for excavating with the arm is from a 45є angle away from the machine to a 30є angle toward the machine. There may be some differences depending on the excavation depth, but try to stay within the above range rather than operating the cylinder at the end of its stroke.

DITCHING WORK Ditching work can be performed efficiently by attaching a bucket to match the width of the ditch. Then, setting the tracks parallel to the line of the ditch to be excavated. To excavate a wide ditch, first dig out both sides and then finally remove the center portion. LOADING WORK In places where the swing angle is small, work can be carried out more efficiently by stopping the dump truck in a place where it can be seen easily by the operator. Loading is easier and the capacity is greater if you load from the rear of the dump truck body than if you load from the side.

SEVERE JOB CONDITIONS When carrying out digging operations in water, if the work equipment mounting pin goes into the water, carry out greasing every time the operation is carried out. For heavy-duty operations and deep digging, carry out greasing of the work equipment mounting pins every time before operation. After greasing, operate the boom, arm and bucket several times, then grease again. 2-118 PC300LC/HD-7E0