OPERATION LIFTING THE MACHINE The operator carrying out the lifting operation using a crane must be a properly qualified crane operator. Never raise the machine with any worker on it. Always make sure that the wire rope is of ample strength for the weight of this machine. When lifting, keep the machine horizontal. When carrying out lifting operations, set the lock lever to the LOCK position to prevent the machine from moving unexpectedly. Never enter the area under or around a raised machine. Never try to lift the machine in any posture other than the posture given in the procedure below or using lifting equipment other than in the procedure below.
There is a hazard that the machine may lose its balance. Remark The lifting method differs according to the attachments and options installed. In such cases, please contact your Komatsu distributor for information. For details of the weight, see See “SPECIFICATIONS” on page 4-2. When lifting the machine, carry out the operation on flat ground as follows. 1. Swing the upper structure so that the work equipment is at the sprocket end (1). 2. Extend the bucket cylinder and arm cylinder fully, then lower the work equipment to the ground as shown using the boom cylinder. 3. Set the lock lever securely in the LOCK position (L) 4.
Stop the engine, check to be sure there is nothing around the oper- ator's compartment, then get off the machine. Close the cab door and front glass securely. PC300LC/HD-7E0 2-129