Komatsu — UNLOADING THE MACHINE

OPERATION 9. Turn auto-deceleration switch (7) OFF and operate the fuel con- trol dial to set the engine speed to low idling. Each time auto-deceleration switch (7) is pressed, it switches OFF ON OFF in turn. When auto-deceleration switch (7) is turned OFF, display monitor (8) goes out. 10. Raise the work equipment, pull in the arm under the boom, then move the machine slowly. 11. When the machine is horizontal on top of the rear wheels of the trailer, stop the machine. Remark When unloading the machine, always keep the arm and boom at an angle of 90 o - 110 o . If the machine is unloaded with the arm pulled in, it will cause damage to the machine.

When moving onto the ramps, do not thrust the bucket into the ground. This will cause damage to the hydraulic cylinders. 12. When moving from the rear of the trailer on to the ramps, set the angle of the arm and boom to 90 Ч to 110 Ч , lower the bucket to the ground, then move the machine slowly. 13. When moving down the ramps, operate the boom and arm slowly to lower the machine carefully until it is completely off the ramps. 2-128 PC300LC/HD-7E0