OPERATION PRECAUTIONS ON PARTICULAR JOBSITES When carrying out digging operations in water, if the work equipment mounting pin goes into the water, grease it every time it comes out of the water. For heavy-duty operations and deep digging, grease the work equipment mounting pins every time before each operation. After greasing, operate the boom, arm, bucket, and blade several times, then grease again. DISCHARGED BATTERY It is dangerous to charge the battery while it is still mounted on the machine. Always remove the battery before charging it. When checking or handling the battery, stop the engine and turn the ignition switch key to the OFF position.
The battery generates hydrogen gas, so there is danger of explosion. Do not bring lighted cigarettes near the battery, or do anything that will cause sparks. Battery electrolyte is diluted sulfuric acid, and it will attack your clothes and skin. If it gets on your clothes or on your skin, wash it off immediately with large amounts of water. If it gets into your eyes, wash it out with fresh water, and consult a doctor. When handling batteries, always wear protective goggles and rubber gloves. When removing the battery, first disconnect the cable from the ground (normally the negative (-) terminal). When installing, install the positive (+) terminal first.
If a tool touches the positive terminal and the chassis, there is danger that it will cause a spark, be extremely careful. If the terminals are loose, there is danger that the defective contact may generate sparks that will cause an explosion. When installing the terminals, install them tightly. When removing or installing the terminals, check which is the positive (+) terminal and which is the negative (-) terminal. Green rust around the terminals is a cause of self-discharge of the battery. Clean the terminals with sandpaper. After removing the rust, coat the terminals thinly with grease before installing. PC300LC/HD-7E0 2-135