Komatsu — BATTERY CHARGES

OPERATION REMOVAL AND INSTALLATION OF BATTERY After fastening the battery in position, check to be sure it does not move. If it moves, check and retighten it. When removing, remove from the ground side terminal first (normally the (-) terminal). Be careful not to touch the positive (+) terminal and the machine with any tool. Letting a tool touch is dangerous as it causes sparks. When installing, connect the ground side last. When replacing the battery, attach the battery securely with the battery mounting clamp. Tightening torque of mounting bolts: 9.8 to 14.7 N•m (7.2 to 10.8 lbf ft) BATTERY CHARGES When charging the battery, there is danger that the battery may explode if it is mishandled.

Follow the instructions in “ELECTRICAL SYSTEM PROBLEMS” on page 2-140 and the instruction manual supplied with the charger, and be sure to observe the following precautions. 1. Set the voltage of the charger to match the voltage of the battery to be charged. If the voltage is not selected correctly, the charger may overheat and cause an explosion. 2. Connect the positive (+) charger clip of the charger to the positive (+) terminal of the battery, then connect the negative (-) charger clip of the charger to the negative (-) terminal of the battery. Be sure to connect the clips securely. 3.

Set the charging current to 1/10 of the value of the rated battery capacity; when doing rapid charging, set it to less than the rated bat- tery capacity. If the charger current is too high, the electrolyte will leak or dry up, and this may cause the battery to catch fire and explode. 4. If the battery electrolyte is frozen, do not charge the battery or start the engine with a different power source. There is a danger that this will ignite the battery electrolyte and cause the battery to explode. 5. Do not use or charge the battery if the battery electrolyte level is below the LOWER LEVEL line. This may cause an explosion.

Always check the battery electrolyte level periodically and add distilled water to bring the electrolyte level to the UPPER LEVEL line. 2-136 PC300LC/HD-7E0