OPERATION BOOSTER CABLE CONNECTION Keep the ignition switch of the normal machine and problem machine at the OFF position. Connect the booster cable as follows, in the order of the numbers marked in the diagram. 1. Make sure that the ignition switches of the normal machine and problem machine are both at the OFF position. 2. Connect one clip of booster cable (A) to the positive (+) terminal of the problem machine. 3. Connect the other clip of booster cable (A) to the positive (+) termi- nal of the normal machine. 4. Connect one clip of booster cable (B) to the negative (-) terminal of the normal machine. 5.
Connect the other clip of booster cable (B) to the upper structure of the problem machine. STARTING THE ENGINE Always check to be sure the safety lock lever is set to the LOCK position, regardless of whether the machine is working normally or has failed. Also check to be sure all the control levers are at the HOLD or neutral position. 1. Make sure the clips are firmly connected to the battery terminals. 2. Start the engine of the normal machine and keep it to running at high idling speed. 3. Turn the ignition switch of the problem machine to the START position and start the engine. If the engine doesn't start at first, try again after 2 minutes or so.
After the engine has started, disconnect the booster cables in the reverse order in which they were connected. BOOSTER CABLE DISCONNECTION 1. Remove one clip of booster cable (B) from the upper structure of the problem machine. 2. Remove the other clip of booster cable (B) from the negative (-) ter- minal of the normal machine. 3. Remove one clip of booster cable (A) from the positive (+) terminal of the normal machine. 4. Remove the other clip of booster cable (A) from the positive (+) terminal of the problem machine. 2-138 PC300LC/HD-7E0