Komatsu — PHENOMENA THAT ARE NOT FAILURES

OPERATION GENERAL TROUBLESHOOTING AFTER RUNNING OUT OF FUEL When starting the engine again after running out of fuel, fill with fuel, then bleed the air from the fuel system before starting the engine. PROCEDURE FOR BLEEDING AIR 1. Insert the key in the starting switch and turn the key to the ON position (B). The electric priming pump is actuated. 2. Hold the key at the ON position (B) for 30 seconds, then return it to OFF position (A) and wait for 10 seconds. 3. Repeat Steps 1 and 2 four times. 4. Turn the key in the starting switch to the START position and start the engine. When doing this, do not crank the starting motor continuously for more than 20 seconds.

If the engine does not start, wait for at least 2 minutes, then try again. Perform this operation a maximum of 4 time PHENOMENA THAT ARE NOT FAILURES When the arm is pulled in, the speed of movement will drop momentarily when the arm reaches vertical (more or less). The arm speed will drop momentarily when the bucket teeth are more or less horizontal. Bucket or arm shakes during heavy-duty digging operations. When starting or stopping the swing, noise will be emitted from the brake valve. When going down a steep slope at low speed, a noise will be emitted from the travel motor brake valve. PC300LC/HD-7E0 2-139