OPERATION ELECTRICAL SYSTEM PROBLEMS (): Always contact your Komatsu distributor when dealing with these items. In cases of abnormalities or causes which are not listed below, please contact your Komatsu distributor for repairs.
2-140 PC300LC/HD-7E0 Problem Main causes Remedy Lamp does not glow brightly even when the engine runs at high speed ● Defective wiring, deterioration of battery ● Loose fan belt ● (Check, repair loose terminals, disconnections, replace battery) ● Check fan belt tension, replace Lamp flickers while engine is running Charge level monitor does not go out even when engine is running ● Defective alternator ● Defective wiring ● (Replace) ● (Check, repair) Abnormal noise is generated from alternator ● Defective alternator ● (Replace) Starting motor does not turn when ignition switch is turned to START position ● Defective wiring ● Defective starting motor ● Insufficient battery charge ● (Check, repair) ● (Replace) ● Charge Drive in starting motor keeps going and out ● Insufficient battery charge ● Defective safety relay ● Charge ● (Replace) Starting motor turns engine sluggishly ● Insufficient battery charge ● Defective starting motor ● Charge ● (Replace) Starting motor disengages before engine starts ● Defective wiring, defective ring gear pinion ● Insufficient battery charge ● (Check, repair) ● Charge Pre-heating monitor does not light ● Defective wiring ● Defective heater relay ● Defective monitor ● (Check, repair) ● (Replace) ● (Replace) Oil pressure monitor does not light up when engine is stopped (ignition switch at ON position) ● Defective monitor ● Defective caution lamp switch ● (Replace) ● (Replace) Outside of the electrical heater is not warm when touched by hand ● Defective wiring ● Open in electrical heater ● Defective heater relay ● (Check, repair) ● (Replace) ● (Replace)