MAINTENANCE DUSTY JOBSITE When working at dusty worksites, do as follows: 1. Check the clogging of the air cleaner more frequently with the dust indicator. Clean the air cleaner element more fre- quently. 2. Clean the radiator core frequently to avoid clogging. 3. Clean and replace the fuel filter frequently. 4. Clean electrical components, especially the starting motor and alternator, to avoid accumulation of dust. 5. When inspecting or changing the oil, move the machine to a place that is free of dust to prevent dirt from getting into the oil. AVOID MIXING LUBRICANTS Never mix different kinds of oil.
If a different type of oil has to be added, drain the old oil and replace all the oil with the new type of oil. LOCKING THE INSPECTION COVERS When servicing the machine with the inspection cover open, lock it in position securely with a lock bar. If inspection or main- tenance is done out with the inspection cover open and not locked in position, there is the possibility that it may suddenly be blown shut by the wind and cause injury to the worker. HYDRAULIC SYSTEM - AIR BLEEDING When hydraulic equipment has been repaired or replaced, or the hydraulic piping has been removed and installed again, the air must be bled from the circuit.
For details, see “BLEEDING AIR FROM HYDRAULIC SYSTEM” on page 3-42. HYDRAULIC HOSE INSTALLATION When removing parts at locations where there are O-rings or gasket seals, clean the mounting surface, and replace with new parts. When doing this, be careful not to forget to assemble the O-rings and gaskets. When installing the hoses, do not twist them or bend them into loops with a small radius. This will cause damage to the hose and markedly reduce its service life. CHECKS AFTER INSPECTION AND MAINTENANCE WORKS If you forget to perform the checks after inspection and maintenance, unexpected problems may occur, and this may lead to serious injury or property damage. Always do as follows. 1.
Checks after operation (with engine stopped) A. Have any inspection and maintenance points been forgotten? B. Have all inspection and maintenance items been carried out correctly? C. Have any tools or parts been dropped inside the machine? It is particularly dangerous if parts are dropped inside the machine and get caught in the linkage mechanism. D. Is there any water or oil leaks? Have all the bolts been tightened? 2. Checks when operating engine A. For details of the checks when operating the engine, see “GENERAL SAFETY RULES” on page 1-9 and pay careful attention to safety. B. Are the inspection and maintenance items working properly? C.
Is there any oil leakage when the engine speed is raised and load is applied to the oil pressure? PC300LC/HD-7E0 3-3