Komatsu — OIL

MAINTENANCE LUBRICANTS, COOLANT AND FILTERS OUTLINE OF SERVICE Always use Komatsu genuine parts for replacement parts, grease or oil. When changing the oil or adding oil, do not mix different types of oil. When changing the type of oil, drain all the old oil and fill completely with the new oil. Always replace the filter at the same time. (There is no problem if the small amount of oil remaining in the piping mixes with the new oil.) Unless otherwise specified, when the machine is shipped from the factory, it is filled with the oil and coolant listed in the table below.

HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC OIL Oil is used in the engine and work equipment under extremely severe conditions (high temperature, high pressure), and it deteriorates with use. Use oil that matches the grade and temperature for use given in the Operation and Maintenance Manual. Even if the oil is not dirty, change the oil after the specified interval. Oil corresponds to blood in the human body, so be careful when handling it to prevent any impurities (water, metal parti- cles, dirt, etc.) from getting in. The majority of problems with machines are caused by the entry of such impurities.

Take particular care not to let any impurities get in when storing or adding oil. Never mix oils of different grades or brands. Add the specified amount of oil. Having too much oil or too little oil are both causes of problems. If the oil in the work equipment is not clear, there is probably water or air getting into the circuit. In such cases, please contact your Komatsu distributor. When changing the oil, replace the related filters. When replacing the engine oil filter, fill the new filter with fresh, clean specified oil before installing. We recommend periodic analysis of the oil to check the condition of the machine.

For those who wish to use this service, please contact your Komatsu distributor. 3-4 PC300LC/HD-7E0 Item Type Engine oil pan Engine oil EO15W40DH (Komatsu genuine parts) Damper case Power train oil TO30 (Komatsu genuine parts) Swing machinery case Final drive case Hydraulic oil system Power train oil TO10 (Komatsu genuine parts) Radiator Supercoolant AF-NAC (density: 50%) (Komatsu genuine parts)