MAINTENANCE ELECTRIC SYSTEM MAINTENANCE It is extremely dangerous if the electrical equipment becomes wet or the covering of the wiring is damaged. This will cause electrical leakage and may lead to malfunction of the machine. Do not wash the inside of the operator's cab with water. When washing the machine, be careful not to let water get into the electrical components. Minimum service relating to the electric system is a check of fan belt tension, check of damage or wear in the fan belt and check of battery fluid level. Never install any electric components other than those specified by Komatsu. External electrical interference may cause malfunction of the control system controller.
Before installing a radio receiver or other wireless equipment, please contact your Komatsu distributor. When working at the seashore, carefully clean the electric system to prevent corrosion. When installing an operator's cab cooler or any other electrical equipment, connect it to an independent power source con- nector. The optional power source must never be connected to the fuse, ignition switch, or battery relay. HANDLING HYDRAULIC SYSTEM During and after operations, the hydraulic system is at high temperature. During operations, it is also under high pressure, so pay careful attention to the following when carrying out inspection and maintenance of the hydraulic system.
Stop the machine on level ground, lower the bucket to the ground, and set it so that there is no pressure on the cylinder cir- cuit. Stop the engine. Immediately after operations, the hydraulic oil and lubricating oil are under pressure and at high temperature, so wait for the temperature to cool before starting maintenance. Even when the temperature cools, there may still be internal pressure. When loosening plugs, screws, or hose connections, do not stand directly in front. Loosen them gradually to release any internal pressure before removing. When carrying out inspection or maintenance of the hydraulic circuits, bleed the air to release the internal pressure.
Minimal inspection or maintenance consists of checking the hydraulic oil level, replacing the filters, and changing the hydraulic oil. When removing high-pressure hoses, check to be sure the O-ring is not damaged. If it is damaged, replace it. 3-8 PC300LC/HD-7E0