MAINTENANCE WEAR PARTS LIST Wear parts such as the filter element, bucket tooth, etc. are to be replaced at the time of periodic maintenance or before their abrasion limits. The wear parts should be changed as scheduled in order to use the machine economically. For part change, Komatsu genuine parts should be used (excellent quality). When ordering parts, please check the part number in the parts book and write them in the table below. The parts in parentheses are to be replaced at the same time. PC300LC/HD-7E0 3-9 Item Part Name Qty Replacement frequency Fuel pre-filter Cartridge (incl.
O-ring) 1 Every 500 hours Engine oil filter Cartridge 1 Every 500 hours Hydraulic tank vent Element 1 Every 500 hours Fuel main filter Cartridge 1 Every 1000 hours Hydraulic oil filter Element (O-ring) 1 (1) Every 1000 hours Corrosion resistor (if equipped) Cartridge 1 Every 1000 hours Additional vent for hydraulic tank Element 1 Every 1000 hours Air conditioner RECIRC filter Filter 1 Every one year Air conditioner FRESH filter Element 1 Every one year Air cleaner Element assembly 1 — Additional filter for breaker (if equipped) Element (O-ring) (O-ring) 1 (1) (1) — Bucket Vertical pin type Tooth (Pin) (Lock) 5 (5) (5) — Horizontal pin type Tooth (Pin) 5 (5) (5) — Side cutter type Cutter (left) Cutter (right) 1 1 — Shroud type Shroud Pin 2 (4) — Ripper bucket Tooth Pin 5 5 —