Komatsu — REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE)

MAINTENANCE REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE) Replace the teeth before the wear reaches the adapter. It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable condition, then stop the engine and apply the locks securely to the levers. If the locking pin is knocked out with excessive force, there is a danger that the pin may fly out. Check to be sure there is no one in the surrounding area. Pieces will often fly during the replacement operation, so always wear safety glasses, gloves, and other protective equipment. 1.

To make it possible to knock out pin (1) of tooth (2), put block (5) under the bottom of the bucket, and set so that the bottom surface of the bucket is horizontal. 2. Check to be sure the work equipment is in a stable condition, then set the lock lever to the LOCK position. 3. Place a bar on the head of pin (1), hit the bar with a hammer to knock out the pin, then remove tooth (2). Remark If the bucket teeth cannot be safely removed by this method, have your Komatsu distributor replace the bucket teeth. 3-34 PC300LC/HD-7E0