MAINTENANCE 4. Clean the mounting face. Fit a new tooth (2) in the adapter, push in pin (1) partially by hand, then lock it with a hammer to install the tooth to the bucket. REPLACE BUCKET SIDE CUTTER, SHROUD It is dangerous if the work equipment is mistakenly moved when replacing the bucket side cutters and shroud. Set the work equipment in a stable condition, stop the engine, then set lock lever securely to the LOCK position (L). SIDE CUTTERS Loosen mounting bolts (2), then remove side cutter (1). Replace the side cutter, bolts, and nuts with new parts. Tightening torque of bolt: 1370 - 1670 Nm (1010 - 1232 ft/lbs) Shroud Loosen the mounting bolts (1) and remove the shroud (2).
Replace the nuts, bolts, and washers with new parts. Tightening torque of bolt: See “TIGHTENING TORQUE SPECIFI- CATIONS (PAGE 3-14)” PC300LC/HD-7E0 3-35