Komatsu — CHECK, ADJUST TENSION OF AIR CONDITIONER COMPRESSOR BELT

MAINTENANCE CHECK, ADJUST TENSION OF AIR CONDITIONER COMPRESSOR BELT CHECKING The deflection of the belt should be 6 to 9 mm (0.23 to 0.35 in) when pressed with a finger force of approx. 58.8N (6 kgf) at mid-point (a) between the crankshaft pulley (B) and the compressor pulley (A). ADJUSTMENT 1. Remove guard (1). 2. Loosen bolts (2) and (3), then move compressor (4) to adjust. Remark When the bolts (2) and (3) are loosened, compressor (4) can move, using the mounting position of bolt (2) as a fulcrum. 3. When the position of the compressor is determined, tighten bolts (2) and (3) to hold it in position. Check each pulley for damage, wear of the V-groove, and wear of the V-belt.

In particular, be sure to check to be sure the V-belt is not touching the bottom of the V-groove. In case any of the following occurs, ask the Komatsu distributor in your territory to replace the belts with new ones. The fan belt has elongated, leaving little allowance for adjustment. A cut or crack is found on the belt. When the new V-belt is set, readjust it after one hour of operation. Slipping or creaking sound is heard coming from the belt. 3-50 PC300LC/HD-7E0